| Last Modified: 11-29-2007 | 1.6 J | |
| Service Category: Audio/Visual/Telematics | Section: Audio/Video | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000001ZYU01DX |
| Title: AUDIO / VIDEO: AUDIO AND VISUAL SYSTEM: DESCRIPTION (2008 Sequoia) | ||
|
Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter |
DESCRIPTION
The stereo jack adapter assembly sends an external device sound signal to the radio receiver assembly through this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier assembly or radio receiver assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, radio receiver assembly, or speakers.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO JACK ADAPTER ASSEMBLY) |
|
(a) Disconnect the I3 radio receiver assembly connector. |
(b) Disconnect the H7 stereo jack adapter assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
I3-17 (ALI) - H7-1 (ALO) |
Always |
Below 1 Ω |
|
I3-15 (ARI) - H7-2 (ARO) |
||
|
I3-16 (ASGN) - H7-3 (ASGN) |
||
|
I3-18 (AUXG) - H7-5 (AUXG) |
||
|
I3-19 (AUXI) - H7-4 (AUXO) |
||
|
I3-17 (ALI) - Body ground |
Always |
10 kΩ or higher |
|
I3-15 (ARI) - Body ground |
||
|
I3-16 (ASGN) - Body ground |
||
|
I3-19 (AUXI) - Body ground |
(d) Reconnect the radio receiver assembly connector.
(e) Reconnect the stereo jack adapter assembly connector.
|
|
|